Mickey: PSU gurus needed Failed project

Dieses Thema im Forum "AMD / ATI" wurde erstellt von hat, 15. November 2018.

  1. hat

    hat Guest

    So, I have a Corsair CX600w. It's not a terrible unit, but the +12v leads burned up, most likely because I was running two GTX1070s at 100% load without any sort of additional power (besides the usual pci-e power connector, of course), drawing too much power from the 24 pin ATX connector. I was able to save the +12v wires by splicing fresh ends on, but the 24 pin connector is (was) burned up. I was able to remove the 24 pin connector from a spare donor unit, but when I went to do the same to...

    PSU gurus needed! Failed project

    Weiterlesen...