Mickey: Baking a printplate over and over again?

Dieses Thema im Forum "AMD / ATI" wurde erstellt von ZoneDymo, 13. Oktober 2021.

  1. ZoneDymo

    ZoneDymo Guest

    Hey hey,

    So Im sure plenty of you are familiar with this method of resurrecting non function hardware.
    Put it in the oven for a while, the solder will supposidely melt and reset itself and after your hardware works.

    I have done this with a few items in the past to good effect.
    But now im a bit puzzled, i have a printplate for a....well printer, and this printer did not function well.
    So I put it in the oven aaaand voila, works like a charm,....and then a bit later it starts acting up a...

    Read more